19
English
Basic operations
This section mainly explains operations commonly used when you
enjoy this system.
• Turn on your TV and select the correct input mode on the TV.
IMPORTANT
Before using the remote control for the
following operation,
• Set the remote control mode selector to
AUDIO
.
7
To turn the power on
On the remote control:
Press
F
AUDIO.
On the center unit:
Press
F
STANDBY/ON.
The STANDBY lamp goes off.
When DVD is selected as the source (
A
pg. 20), the opening
screen* appears on the TV screen.
*
Opening screen
The following messages may
appear in the message area
depending on the status of this
system.
• “OPEN”/“CLOSE”:
Appears when opening or
closing the selected disc tray.
• “NOW READING”:
Appears when the system is
reading the disc information.
• “REGION CODE ERROR!”:
Appears when the Region Code of the DVD does not match the
code the center unit supports. The DVD cannot be played back.
• “NO DISC”:
Appears when no disc is loaded to the selected disc tray.
7
To turn the power off
On the remote control:
Press
F
AUDIO again.
On the center unit:
Press
F
STANDBY/ON again.
The STANDBY lamp lights.
NOTE
• The power supply to the subwoofer is linked to the center unit. The
POWER ON lamp on the subwoofer lights green when the power is
turned on.
• A small amount of the power is consumed even when the power is
turned off (center unit only). This is called standby mode and the
STANDBY lamp lights in this mode. Unplug the power cord from the
AC outlet to turn the power off completely.
• You can also turn on the system by pressing the following buttons;
•
One of
0
buttons on the center unit
•
One of the source selecting buttons on the remote control
•
One of the
DISC (1-5)
buttons or
3
on the center unit.
You can use the same buttons on the remote control except after
pressing
FM/AM
.
Source
selecting
buttons
Remote control
mode selector
Illumination lamp
Disc lamps (TH-M65 only)
(TH-M45 only)
Turning the system on/off
Message area
TH-M65-45[UW]-05Basic.fm Page 19 Friday, June 13, 2003 10:23 AM