2.9 Drive Detection Mode
(1) Purpose
Drives are detected in order to prevent simultaneous installation of different drives.
(2) Start
While pressing the “8” key, turn the power ON.
(3) Operation
After the initial operation, each of the installed drives performs the ejection operation for identification.
* Be sure to turn the power OFF and then ON again after drive detection.
D E T E C T I N G D R I V E S
. . . . P L E A S E W A I T
D R I V E D E T E C T I O N
C O M P L E T E D
LCD display during drive detection
LCD display after drive detection
Note: Whenever a drive is added, replaced or removed after the last drive
detection, be sure to repeat drive detection.
* If this is omitted, a mechanism malfunction may result.
2-17
Содержание MC-8200LU
