(No.49879)1-13
3.2.4 Removing the clamper unit
(See Fig.5 ~ 9)
• Prior to performing the following procedure, remove the top
cover and the mechanism section.
(1) Remove the clamper spring on the bottom of the mecha-
nism section.
(2) Release part
d
of the clamper spring from the bending part
of the chassis base assembly.
(3) Move the clamper unit in the direction of the arrow and turn.
Release the two joints
e
and
f
, then remove the clamper
unit upward.
3.2.5 Reattaching the clamper unit
(See Fig.5 ~ 9)
(1) Attach the clamper spring to the clamper unit.
(2) Move the clamper unit to set the side joints
e
and
f
to each
boss of the chassis base. Make sure that part
g
is inserted
to the notch of the chassis base.
(3) Move the clamper spring
d
to the outside of the bending
part of the chassis base.
Caution:
When reattaching, temporarily hook the end of the clamper
spring as shown in the figure to make the work easy.
Fig.5
Fig.6
Fig.7
Fig.8
Fig.9
Clamper unit
Clamper spring
Clamper2 spring
g
f
e
Chassis base
Clamper2 spring
Clamper spring
Chassis base
d
Clamper unit
Clamper spring
Notch
g
Clamper unit
Содержание KD-DV5000
Страница 29: ... No 49879 1 29 ...