(No.49879)1-11
3.2
DVD mechanism assembly
3.2.1 Removing the front end board
(See Fig.1)
Caution:
Before disconnecting the flexible wire extending from the DVD
pickup, solder the short-circuit point on the flexible wire using
a grounding soldering iron. If you do not follow this instruction,
the DVD pickup may be damaged.
(1) Turn over the body, and solder the short-circuit point on the
flexible wire extending from the DVD pickup.
(2) Disconnect the flexible wire from connector
CN10
on the
front end board.
(3) Disconnect the flexible wire from connector
CN201
on the
front end board.
(4) Disconnect the flexible wire from connector
CN202
on the
front end board.
(5) Unsolder two soldering
a
on the front end board and dis-
connect the wire extending from the feed motor.
(6) Remove the three screws
A
attaching the front end board.
Caution:
As the flexible wire to be connected to
CN10
, make sure to at-
tach it to the front end board using a double tape.
Caution:
After reassembling, unsolder the short-circuit point.
Fig.1
Double tape
Feed motor
Solder point
Front end board
CN202
CN10
A
a.
A
A
CN201
Flexible wire
Short-circuit point
Содержание KD-DV5000
Страница 29: ... No 49879 1 29 ...
