64
USING EXTERNAL COMPONENTS
Connecting the Video
Signal Cables
Connecting the IEEE1394 Cable
To reduce the emission of unwanted radio waves, be sure to
attach the provided clamp filter as shown in the figure below.
• Attach the clamp filter as close to this device as possible,
as shown in the figure.
• Set the IEEE1394 switch on the left panel of this device.
CAUTION
When connecting the IEEE1394 cable from/to Camcorder,
VCR and other IEEE1394 device, make sure the following
instructions, otherwise the IEEE1394 circuit device may be
destroyed.
• Turn the power of both devices OFF and connect the
IEEE1394 cable.
• Do not insert incorrectly (in reverse) the IEEE1394 cable
end to IEEE1394 port of both devices.
• Do not connect the IEEE1394 cable under the condition
of static electricity.
• Turn the power of both devices OFF when changing the
IEEE1394 switch from/to HDV/DV.
Displaying Alarms
• CHANGE 1394 SWITCH
Displayed when the setting for the input/output video format
from the IEEE1394 connector and the setting for the
IEEE1394 switch are different.
Set the IEEE1394 switch so it matches the video format.
DV
: DV format
HDV
: HDV format
IEEE 1394
CH2-AUDIO OUT-CH1 VIDEO
IEEE1394 switch
Clamp filter
Wind once
IEEE 1394
IEEE 1394
X
C H A N G E 1 3 9 4 S W I T C H
e_hd250.book Page 64 Tuesday, October 24, 2006 3:11 PM
