6
Installation
Precautions
• Before installation, peel the protective film off from the clear panel attached to the front panel.
• When installing the monitor, be sure to use a dedicated stand unit or wall mounting unit, depending on your
particular case. Ask your dealer to install.
• When installing the monitor in a special way (for example, installing it diagonally), consult your dealer.
• Route the power cord and connection cables along the wall or floor corners to avoid walking on them.
• For good heat dissipation, try to leave the following distance of space (minimum) around the monitor (see
diagram below).
• The ambient temperature of the installation place should be within the range of 0°C to 40°C (32°F – 104°F)
(slightly variable depending on ambient conditions for installation).
• When installing the monitor near the ceiling or similar location, the remote control may not work correctly
because of possible effects, such as reflections, from the surroundings. If this happens, move the monitor where it
is free from these effects.
• Do not install the monitor in such a way that the monitor and other AV equipment affect each other adversely.
(For example, if a disturbed image or noise due to electromagnetic interference occurs, or if the infrared remote
control malfunctions, change the installation place.)
When installing the monitor on a stand
Front view
Side view
150
(6)
150
(6)
50 (2)
50 (2)
200 (7 7/8)
15 (5/8)
200 (7 7/8)
100 (4)
100
(4)
100
(4)
Unit: mm (inch)
When mounting the monitor on the wall
Front view
Side view
Unit: mm (inch)
When installing the monitor vertically
• Make sure to install the monitor in the direction illustrated on the
right.
• Set the speed of the internal cooling fan to “HIGH” (see “COOLING
MODE” on page 16).
Connecting external speakers
You can connect commercial speakers of the following specifications to the EXT. SPEAKER terminal:
• Impedance: Between 6 Ω and 8 Ω
• Power handling capacity: More than 3 W
Speakers
(commercially available)
Ferrite core (supplied)
To reduce interference from the monitor on
external equipment, attach the supplied ferrite
cores near to the EXT. SPEAKER terminals on the
rear panel of the monitor.
CAUTION
• Do not short-circuit
9
and
(
speaker cords to each other. (Refer also to the instructions supplied with the
speakers.)
NOTE
• When using the external speakers, set “SPEAKER SELECT” on the main menu to “EXT. (external)” (see page 12).
Speakers
(commercially available)
GM-H40L2UA_resize-2.indd 6
GM-H40L2UA_resize-2.indd 6
06.7.28 1:44:08 PM
06.7.28 1:44:08 PM