1-8 (No.XA019)
3.1.3 Remove the mechanism assembly (See figure 5)
• Prior to performing the following procedure, remove the top
cover.
• There is no need to remove the front panel assembly.
(1) Disconnect the socket wire from connector
CN451
on the
servo control board.
(2) Disconnect the card wire from connector
CN2201
on the
digital board.
(3) Remove the four screws
C
attaching the mechanism as-
sembly.
Fig.5
3.1.4 Remove the digital board (See figure 6, figure 7)
• Prior to performing the following procedure, remove the top
cover.
(1) Disconnect the card wire from connector
CN2201
on the
digital board.
(2) Remove the four screws
D
and
E
attaching the digital
board.
(3) Remove the one screw
F
attaching the jack board.
(4) Lift the digital board up, and remove it. Then, the digital
board is removed from the connectors
CN4101
,
CN4102
on the main board. In attaching the digital board, insert the
connector on the digital board in these connectors secure-
ly.
Fig.6
Fig.7
C
Mechanism assembly
C
CN2201 C
C
CN451
Digital board
E
F
D
D
CN2201
E
Digital board
Jack board
Digital board
Main board
CN4101
CN4102
Содержание DR-M10SUC
Страница 13: ... No XA019 1 13 SECTION 4 ADJUSTMENT This service manual does not describe ADJUSTMENT ...
Страница 19: ... No XA019 1 19 ...
Страница 67: ...2 46 ...