Juniper WLA620, Руководство по установке

Страница: 50 / 96

Installing and Connecting an Access Point
16 Copyright © 2012, Juniper Networks, Inc.
2. Position the bracket in the intended location and mark the position of the four
mounting screw holes.
3. Drill four holes in the wall that match the screws and wall plugs included in the
bracket kit, then secure the bracket to the wall.
4. Use the included nuts to tightly secure the WLA622 to the bracket.
Connecting External Antennas
For some applications, when deploying an WLA622, you must mount external antennas
and connect them to the unit. Typically, access point operation requires a 2.4 GHz
antenna, and bridge link operation requires a 5.0 GHz antenna.
The primary port for 802.11bg (2.4Ghz) is port 1 and the primary port for 802.11a is Port
3. The WLA622 supports one or two antennas connected to each band. If you install
one antenna it must be installed in the primary port. If you install two antennas they
must be the same antenna model. There are no additional configuration requirements
for adding the second antenna. If antenna diversity between the two antennas is a
desired option it must be configured.
The default for the 802.11bg radio is ANT-1360-OUT.
set ap apnum radio num antennatype {ANT-1120-OUT | ANT-1360-OUT |
ANT-5360-OUT | ANT-5120-OUT | ANT-5PNL-OUT}
The antenna-location must be either indoors or outdoors. Placing and configuring one
antenna indoors and the other outdoors is not allowed.
set ap apnum antenna-location {indoors | outdoors}
To connect external antennas follow these steps:
1. Mount the external antenna to the same supporting structure as the WLA622, within
10 ft (3 m) distance, using the bracket supplied in the antenna package.
2. If you are installing the optional lightning arrestor for an outdoor antenna, perform
the following steps. Otherwise, skip to step 5.