JUNOSe 11.1.0 Release Notes
22
Known Behavior
bgpConnections (default,0.0.0.0): TCP error code xx (...) occurred while accepting
inbound TCP connection
The message is generated when an unconfigured peer attempts to establish a
TCP session with an E Series router and a valid route to the source address of
the peer is absent from the router’s routing table.
If a valid route exists in the routing table, the following message is displayed
when an unconfigured peer attempts to establish a TCP session with an E
Series router; X.X.X.X is the source address of the unconfigured peer:
NOTICE 08/29/2001 16:50:11 bgpConnections (default,X.X.X.X): Inbound
connection refused - no peer X.X.X.X configured in core
BGP/MPLS VPNs
NAT does not function properly with secondary routing table lookup (fallback
global) or global export mapping on the VRF.
B-RAS
Pool groups are not supported; although the
ip local pool group
command
appears in the CLI, it is not supported.
If the router is under a heavy load, the
show profile
command might take
longer than usual to execute.
Work-around:
You can either delay examination of profiles until the router is
less busy, or save a copy of the profile to a text file off the router.
CLI
In Interface Configuration mode for a major interface, the CLI displays options
for protocols that are not supported by that interface type.
When you issue the
reload
command on an ERX310 router, the command
might display a warning message that erroneously indicates that a
synchronizing operation will be performed. Any references to synchronization
that appear in command output or system messages do not apply to the
ERX310 router, which does not support SRP module redundancy.
The following commands have been deprecated in the JUNOSe Software and
might be removed completely in a future release. If a command has been
deprecated for only a particular command mode, the table specifies any modes
for which it is still available.
Deprecated Command
Command Mode
Preferred Command
aaa accounting interval
Global Configuration
aaa service accounting
interval and
aaa user accounting interval
cablelength short
Controller Configuration
channel-group description
Controller Configuration
channel-group shutdown
Controller Configuration