Release Highlights
13
Release 11.1.0
You can use the
mirror-enable
command to configure this feature through the
CLI. The DHCP Option 82 identification method is used to trigger mirroring
only for DHCP subscribers. The Agent Circuit ID and Agent Remote ID
identification methods are used to trigger mirroring for both PPP and DHCP
subscribers.
Change in existing behavior:
New feature added as described here.
Policy Management
Support for HTTP Redirect on ES2 10G ADV LM
You can now create an exception rule within an IP policy classifier group for
the ES2 10G ADV LM. The exception rule enables an application such as HTTP
redirect to perform application-dependent action on the content of the packet.
To create the exception rule, use the
exception http-redirect
command.
Change in existing behavior:
Existing feature extended as described here. In
lower-numbered releases, an IP policy with
exception http-redirect
as the
action was not supported on the ES2 10G ADV LM.
Support for IPv6 HTTP Redirect on ES2 10G LM
You can now create an exception rule within an IPv6 policy classifier group for
the ES2 10G LM. The exception rule enables an application such as HTTP
redirect to perform application-dependent action on the content of the packet.
To create the exception rule, use the
exception http-redirect
command.
Change in existing behavior
: Existing feature extended as described here. In
lower-numbered releases, the ES2 10G LM did not support an IPv6 policy with
exception http-redirect
.
Support for CAM Classifier Size of 144-Bit
You can now configure content-addressable memory (CAM) hardware classifier
entries to be 144 bits for IPv6 policies on the ES2 10G LM or the ES2 10G
Uplink LM. The number of 144-bit classifiers supported on the ES2 10G LM is
256K and on the ES2 10G Uplink LM is 128K.
Change in existing behavior:
Existing feature extended as described here. In
lower-numbered releases, the number of 144-bit classifiers supported on the
ES2 10G LM was 128K and the number of 144-bit classifiers supported on the
ES2 10G Uplink LM was 64K.
SDX Software and SRC Software
Transfer of Calling Station ID to PDP
JUNOSe Software now supports sending of the calling station ID to the Policy
Decision Point (PDP) for a virtual router. To enable this, use the
sscc option
send-calling-station-id
command in Global Configuration mode.
The following command has been modified in this release:
sscc option