Known Problems and Limitations
45
Release 10.3.1
On E320 line modules that support secure policies, the SRP module enables
you to configure more than 1022 secure policies per module. [Defect ID
175756/180360]
Work-around
: To avoid potential performance issues, we recommend that you
do not configure more than 1022 secure policies per module.
Unified in-service software upgrade (unified ISSU) is not supported on an E120
or E320 router if a hierarchical policy is attached to an external parent group.
[Defect ID 177478]
When you enter the
no ip policy-parameter hierarchical
parameterName
command or
no ipv6 policy-parameter hierarchical
parameterName
command for a hierarchical policy-parameter type in Interface Configuration
mode, the explicit reference of the parameter is removed successfully from the
interface. However, the Referenced by interfaces field in the output of the
show policy-parameter
command does not change from the previously
configured value to implicit. [Defect ID 183957]
Work-around
: To correct this problem, remove the entire interface
configuration.
PPPoE
The E Series router erroneously accepts a PADI with a payload length of 0
instead of rejecting it and incrementing the PPPoE Invalid PAD packet length
counter. [Defect ID 48356]
QoS
You cannot paste a
load-rebalance
command string that uses the
percent
option into a console or Telnet session from
show configuration
output
because the output displays the % sign rather than the
percent
keyword that
was submitted with the command and the percent sign is not recognized by
the CLI. [Defect ID 81705]
The router cannot resolve inconsistent requests caused by two QoS profiles
that modify the same scheduler property inconsistently. [Defect ID 61485]
Work-around
: Avoid using two QoS profiles that modify the same scheduler
property inconsistently, such as setting different values for the shaping rate for
the same S-VLAN node.
When you perform an SNMP walk of the juniQosQueueStatistics MIB, a timeout
of up to 5 minutes ensues, during which the SRP module CPU utilization goes
to 100 percent. [Defect ID 62252]
