Known Problems and Limitations
35
Release 10.3.1
When you use the
no-authenticate
keyword with the
subscriber
command to
prevent subscriber authentication so that the subscriber information can be
used for DHCP option 82, suboption 2, the SRP module can reset. This issue
does not occur when you use the
no-authenticate
keyword with the
subscriber
command as a way to perform a RADIUS configuration. [Defect ID
69865]
When you perform an snmpWalk on the juniAtmSubIfVccTable, a response is
received for only a few of the total configured ATM subinterfaces when both of
the following are true: the router has a line module that has some ATM-related
configuration and the line module is in the disabled state. [Defect ID 80020]
The
baseline interface atm
command fails for a VCD assigned by the router to
F4 OAM circuits. [Defect ID 174482]
Unified ISSU is not supported when ILMI is configured on ATM interfaces.
[Defect ID 176007/177297/177122]
ATM line modules reset after unified ISSU completes at the LAC when an
MLPPP bundle with three links are tunneled to the LNS. [Defect ID 178821]
For PPPoE, the AAL5 inPacket Discards counter might increment erroneously
during call setup when a packet is passed directly to PPPoE for negotiation
rather than being discarded. [Defect ID 51757]
Work-around:
Incremental InPacketDiscards during call setup do not
necessarily indicate a problem. However, we recommend you investigate an
excessive count because that might indicate a connection that cannot be
successfully brought up for some reason, such as RADIUS denials or improper
configuration.
The inPacketOctetDiscards counter in the output of the
show atm vc atm
interface
vcd
command includes both inBytesDropped and
inBytesUnknownProtocol statistics. The inBytesUnknownProtocol statistics
should be displayed by a separate counter.
At the major interface level, the inPacketDiscards counter includes both
inPacketsDropped and inPacketUnknownProtocol statistics. The
inPacketUnknownProtocol statistics should be displayed by a separate counter.
[Defect ID 44286]
When you configure an ATM PVC where PCR = SCR and maximum burst size
is zero, the CLI returns an error indicating the burst size is invalid and it does
not create the VC. [Defect ID 58357]
Work-around:
Configure a CBR or a UBR plus PCR to create the circuit with the
same parameters, depending on the desired priority for the traffic. CBR has a
high priority and UBR plus PCR has a medium priority.
BFD
After you have shut down the interface to the next hop (for the route that is
used to establish the BFD session), output for the
show bfd session
command
erroneously indicates the shutdown interface as Management Interface
(FastEthernet 6/0). [Defect ID 174271]
