Juniper IP SERVICES - CONFIGURATION GUIDE V 11.1.X, Руководство по настройке

Страница: 35 / 366

You can, however, remove the lists with the set comm-list delete command if you
created them separately with the following commands:
host1(config)# ip community list 1 permit 231:10
host1(config)# ip community list 1 permit 231:20
Matching a Policy List
You can use the match policy-list command to reference a policy list within the
route map. Policy lists are like route maps, but they contain only match clauses and
no set clauses. You can create a policy list to contain a group of match clauses once,
referencing the list in any number of route maps and avoiding the task of having to
reenter the match clauses separately into each route map.
For more information about creating IP policy lists, see “Match Policy Lists” on
page 20.
Redistributing Access Routes
Access-internal routes, such as DHCP and AAA/PPP host routes, are host routes to
directly connected clients. Access routes, also known as AAA framed routes, are
sourced by AAA.
The following example shows how you might redistribute access-internal routes and
access routes by matching on a tag:
1.
Configure route map tagtest to match tag 30.
host1(config)# route-map tagtest
host1(config-route-map)# match tag 30
2.
Configure redistribution into BGP of the access-internal routes and access routes
with route map tagtest.
host1(config)# router bgp 405
host1(config-router)# redistribute access route-map tagtest
host1(config-router)# redistribute access-internal route-map tagtest
Setting Multicast Bandwidths
You can use the set admission-bandwidth command to set a multicast bandwidth
for admission control. Admission control is performed for the join and mapped
interface when the OIF is added to the mroute.
You can use the set qos-bandwidth command to set a multicast bandwidth for QoS
control. The QoS adjustment is made to the join interface when the OIF is added to
the mroute.
NOTE: Both the admission bandwidth and QoS bandwidth are a constant bit rate.
Route Maps
■ 9
Chapter 1: Configuring Routing Policy