Jungheinrich ETX ac 125, Руководство по эксплуатации

Страница: 57 / 89

501
1
838
6 GB
E 28
– Push “Guidance” (23) button.
– The drive wheel is automatically set
straight and the indicator lamp
“Guidance ON” (24) is shown in
reverse video. Manual steering is out
of operation.
– Continue to drive the truck at the
desired speed in the narrow aisle.
Trucks with inductive guidance
f
When starting or continuing to travel after switching of inductive guidance you must
observe the position of the drive wheel, as manual steering is active again.
f
If an inductively forced guided truck is switched off, the inductive guidance will no
longer be active when the truck is switched on again. Danger of accidents! The truck
must be tracked in again.
f
During the tracking-in procedure the truck’s rear section might break out of line under
certain circumstances, if the front sensor (3) has already crossed the guide wire
before the button “Inductive guidance ON” has been pushed.
– Drive the truck (1) diagonally at
reduced speed towards the guide wire
(2).
When tracking-in, the truck must not be
in parallel to the guide wire and the
approaching angle should be between
10° and 35°.
The tracking-in procedure should be
performed in load direction, since the
required time and distance are smallest
in this direction.
– When near the guide wires of the
inductive guidance system, actuate
pushbutton (23).
The indicator lamp “Inductive guidance
active” (24) illuminates.
When the guide wire is reached, the
truck is automatically guided.
The tracking-in procedure is
automatically executed at reduced travel
speed when the guide wire is reached.
The display for “Tracking-in” (35) lights
up. The auditive tracking signal is
sounded.
3
1
2
501
1
838
6 GB
E 28
– Push “Guidance” (23) button.
– The drive wheel is automatically set
straight and the indicator lamp
“Guidance ON” (24) is shown in
reverse video. Manual steering is out
of operation.
– Continue to drive the truck at the
desired speed in the narrow aisle.
Trucks with inductive guidance
f
When starting or continuing to travel after switching of inductive guidance you must
observe the position of the drive wheel, as manual steering is active again.
f
If an inductively forced guided truck is switched off, the inductive guidance will no
longer be active when the truck is switched on again. Danger of accidents! The truck
must be tracked in again.
f
During the tracking-in procedure the truck’s rear section might break out of line under
certain circumstances, if the front sensor (3) has already crossed the guide wire
before the button “Inductive guidance ON” has been pushed.
– Drive the truck (1) diagonally at
reduced speed towards the guide wire
(2).
When tracking-in, the truck must not be
in parallel to the guide wire and the
approaching angle should be between
10° and 35°.
The tracking-in procedure should be
performed in load direction, since the
required time and distance are smallest
in this direction.
– When near the guide wires of the
inductive guidance system, actuate
pushbutton (23).
The indicator lamp “Inductive guidance
active” (24) illuminates.
When the guide wire is reached, the
truck is automatically guided.
The tracking-in procedure is
automatically executed at reduced travel
speed when the guide wire is reached.
The display for “Tracking-in” (35) lights
up. The auditive tracking signal is
sounded.
3
1
2