Jungheinrich ETX ac 125, Руководство по эксплуатации

Страница: 24 / 89

C 3
501
1
838
6 GB
4 Initial operation
m
The truck may only be operated with the
prescribed battery! Rectified alternate
current will damage the electronic
components. Cables connected to the
battery (trailing cables) must be less
than 6 meters in length.
In order to prepare the truck for work
following delivery or transportation, the
following operations must be performed:
– If necessary, install and charge
battery (refer to chapter D).
– Bring the truck into service as detailed
in chapter E.
Tilting safety device
Some trucks are delivered with a tilting safety device (5) (f this is prescribed in the
order). Before bringing commissioning the truck the tilting safety device must be reset
to a distance of 10 to 12 mm to the ground by means of washers.
The tilting safety device must be checked for tight seating on a daily basis.
If the ground clearance is smaller than 10 mm (due to tyre wear) the tilting safety
device must be reset again to a distance of 10 to 12 mm to the ground by removing
some of the washers.
If the wheel diameter has been reduced by 10 to 15 mm due to wear, the wheel must
be changed.
f
Setting the tilting safety device as well as changing a wheel may only be performed
by authorised technicians of the manufacturer.
5
C 3
501
1
838
6 GB
4 Initial operation
m
The truck may only be operated with the
prescribed battery! Rectified alternate
current will damage the electronic
components. Cables connected to the
battery (trailing cables) must be less
than 6 meters in length.
In order to prepare the truck for work
following delivery or transportation, the
following operations must be performed:
– If necessary, install and charge
battery (refer to chapter D).
– Bring the truck into service as detailed
in chapter E.
Tilting safety device
Some trucks are delivered with a tilting safety device (5) (f this is prescribed in the
order). Before bringing commissioning the truck the tilting safety device must be reset
to a distance of 10 to 12 mm to the ground by means of washers.
The tilting safety device must be checked for tight seating on a daily basis.
If the ground clearance is smaller than 10 mm (due to tyre wear) the tilting safety
device must be reset again to a distance of 10 to 12 mm to the ground by removing
some of the washers.
If the wheel diameter has been reduced by 10 to 15 mm due to wear, the wheel must
be changed.
f
Setting the tilting safety device as well as changing a wheel may only be performed
by authorised technicians of the manufacturer.
5