11
.1
4
E
N
76
5.1
Truck does not start
5.2
Load cannot be lifted
Possible Cause
Remedy
Battery connector not inserted
Check the battery connector
and insert if necessary
Emergency Disconnect switch pressed
Release the Emergency Disconnect
switch, see page 61
Key switch set to O
Set the key switch to “I”
Deadman switch not pressed
Press deadman switch
Battery charge too low
Check battery charge,
Charge battery if necessary, see page 37
Faulty fuse
Check fuses see page 119
Incorrect ISM access module transponder
used
Use correct transponder
Incorrect CANCode PIN entered
Enter correct PIN, see page 85
Possible Cause
Remedy
Truck not operational
Carry out all measures listed under “Truck
does not start”
Hydraulic oil level too low
Check the hydraulic oil level see page 117
Battery discharge monitor has switched
off
Charge the battery, see page 37
Faulty fuse
Check fuses see page 119
Excessive load
Note maximum capacity, see data plate
Switch in mast implausible
(event message E-2124 appears in the
display and control unit (
o
)
– Lowering and travelling possible up to
1.5 km/h
– Park the truck securely, see page 53.
– Contact the manufacturer's customer
service department.
Ramp lift activated, wheel arms raised When ramp lift is activated the load can
only be raised up to 1800 mm. Lower the
wheel arms, see page 71.
Содержание ESC 316
