Jungheinrich ERE 224, Руководство по эксплуатации

Страница: 52 / 87

E 23
1003
.GB
5.5 Travel parameters
Z
For trucks without indicator instrument (CANDIS (
o
)) the code lock parameters can
only be set by the manufacturer's service.
The following example shows the parameter setting for the acceleration of travel pro-
gram 1 (parameter 101).
Acceleration example
– Select the edited travel program after changing the parameter value, confirm with
the Set key (21).
– Check the LC display of the indicator instrument (CANDIS (
o
)) (parameter number
and current parameter value are displayed).
Z
If there is no input for approx. 5 seconds, the display switches back to operating hours
indication.
F
If another parameter number than the one displayed is desired, you must wait until
the operating hours are displayed again.
– Enter or change the parameter value according to the parameter list.
– Check the LC display of the indicator instrument (CANDIS (
o
)) (confirm with the
Set key (21)).
– The LED (20) of the
o
-key (25) switches briefly to steady light and start flashing
again after approx. 2 seconds.
Z
When the input is incorrect, the LED (20) of the
o
-key (25) lights up red. After
entering the parameter number again, the setting value can be entered or changed.
Repeat the procedure to enter further parameters as soon as the LED (20) of the
o
-key (25) flashes. To terminate the input, press the
o
-key (25).
Display instrument
(CANDIS)
LED (20)
o
-key
LED (22)
Key 1
LED (23)
Key 2
LED (24)
Key 3
current setting is
displayed
101 6
green
flashing
off off off
changed setting is
displayed
101 8
green
flashing
off off off
Parameter
number
Parame-
ter set-
ting value
E 23
1003
.GB
5.5 Travel parameters
Z
For trucks without indicator instrument (CANDIS (
o
)) the code lock parameters can
only be set by the manufacturer's service.
The following example shows the parameter setting for the acceleration of travel pro-
gram 1 (parameter 101).
Acceleration example
– Select the edited travel program after changing the parameter value, confirm with
the Set key (21).
– Check the LC display of the indicator instrument (CANDIS (
o
)) (parameter number
and current parameter value are displayed).
Z
If there is no input for approx. 5 seconds, the display switches back to operating hours
indication.
F
If another parameter number than the one displayed is desired, you must wait until
the operating hours are displayed again.
– Enter or change the parameter value according to the parameter list.
– Check the LC display of the indicator instrument (CANDIS (
o
)) (confirm with the
Set key (21)).
– The LED (20) of the
o
-key (25) switches briefly to steady light and start flashing
again after approx. 2 seconds.
Z
When the input is incorrect, the LED (20) of the
o
-key (25) lights up red. After
entering the parameter number again, the setting value can be entered or changed.
Repeat the procedure to enter further parameters as soon as the LED (20) of the
o
-key (25) flashes. To terminate the input, press the
o
-key (25).
Display instrument
(CANDIS)
LED (20)
o
-key
LED (22)
Key 1
LED (23)
Key 2
LED (24)
Key 3
current setting is
displayed
101 6
green
flashing
off off off
changed setting is
displayed
101 8
green
flashing
off off off
Parameter
number
Parame-
ter set-
ting value