Jungheinrich ERE 120n, Руководство по эксплуатации

Страница: 45 / 93

111
3
.G
B
E 16
5.4 Parameter Settings
To change the truck setting you must enter the master code.
Z
The factory setting for the master code is 7-2-9-5.
M
When starting the truck for the first time, change the master code (see Section 5.1).
F
Safety instructions for trucks with a display instrument (CanDis (
o
))
– Parameter settings must be made carefully and only by special trained personnel.
If in doubt, consult the manufacturer's service department.
– Every setting procedure must be monitored on the LC display of the display
instrument (
o
). If in doubt, the setting procedure must be cancelled by pressing the
o
key (21).
– Since changing any parameter will affect the truck's travel pattern, you must carry
out a test run in a specially designated work area.
To enter the master code:
– Press the
o
key
– Enter master code
Code Lock Parameters
Setting procedure for trucks without display instrument (CanDis (
o
)):
– Enter the three digit parameter number, confirm with the Set key (17).
– Enter the setting according to the parameter list or change and confirm with the Set
key (17).
Z
If the entry is incorrect, the LED (16) of the
o
key (21) flashes red. If you enter the
parameter number again the setting can be entered or changed.
– To enter more parameters, repeat the procedure.
– When all the parameters have been entered, carry out the “SaveParameters”
function by pressing keys 1-2-3-Set.
– When you have finished entering the parameters, press the
o
button (21).
Display instrument
(CanDis)
LED (16)
o
key
LED (18)
Key 1
LED (19)
Key 2
LED (20)
Key 3
Service hours
are indicated
284
.
0
Green
flashing
Off Off Off
111
3
.G
B
E 16
5.4 Parameter Settings
To change the truck setting you must enter the master code.
Z
The factory setting for the master code is 7-2-9-5.
M
When starting the truck for the first time, change the master code (see Section 5.1).
F
Safety instructions for trucks with a display instrument (CanDis (
o
))
– Parameter settings must be made carefully and only by special trained personnel.
If in doubt, consult the manufacturer's service department.
– Every setting procedure must be monitored on the LC display of the display
instrument (
o
). If in doubt, the setting procedure must be cancelled by pressing the
o
key (21).
– Since changing any parameter will affect the truck's travel pattern, you must carry
out a test run in a specially designated work area.
To enter the master code:
– Press the
o
key
– Enter master code
Code Lock Parameters
Setting procedure for trucks without display instrument (CanDis (
o
)):
– Enter the three digit parameter number, confirm with the Set key (17).
– Enter the setting according to the parameter list or change and confirm with the Set
key (17).
Z
If the entry is incorrect, the LED (16) of the
o
key (21) flashes red. If you enter the
parameter number again the setting can be entered or changed.
– To enter more parameters, repeat the procedure.
– When all the parameters have been entered, carry out the “SaveParameters”
function by pressing keys 1-2-3-Set.
– When you have finished entering the parameters, press the
o
button (21).
Display instrument
(CanDis)
LED (16)
o
key
LED (18)
Key 1
LED (19)
Key 2
LED (20)
Key 3
Service hours
are indicated
284
.
0
Green
flashing
Off Off Off