Switching on light for the duration of the run-on time
A 2-wire extension or an installation button is connected.
o
Press 2-wire extension or installation button, with dimming inserts alternative
Å
button, for less than 0.4 seconds.
Light is switched on depending on brightness and motion. Motions are evaluated further
and prolong the run-on time.
i
The light cannot be switched off manually.
i
In short time operation, cyclic pulses take place whilst the 2-wire extension or installation
button is pressed.
Light On for 2 hours
i
This function is not adjustable in short time operation.
o
Press
Â
button of the IR remote control.
Light is switched on for 2 hours. The motion detector is in automatic operation again after
the 2 hours have elapsed. If no motions are detected, the light stays on for a run-on time of
4 minutes. If motions are detected, the light stays on for the duration of the set run-on time.
i
With the HVAC insert, only output
Kanal 1
is switched on, output
HLK
continues switching
motion-dependent.
Light Continuous on
i
This function is not adjustable in short time operation.
o
Press
¿
button for less than 0.4 seconds or button (7) on the motion detector.
Light is switched on continuously. The yellow LED lights up.
i
With the HVAC insert, only output
Kanal 1
is switched on, output
HLK
continues switching
motion-dependent.
Switching off On for 2 hours or Continuous on
o
Press
À
button, for Continuous on function press alternative button (7) on the motion
detector.
Automatic operation is set. If no motions are detected, the light stays on for a run-on time
of 4 minutes. If motions are detected, the light stays on for the duration of the set run-on
time.
Light Off for 2 hours
Motions are not evaluated during this time. It is not possible to switch on via a 2-wire extension
or installation button.
o
Press the
Ã
button.
Light is switched off for 2 hours. After the time has elapsed ,the motion detector is in
automatic operation again.
i
With the HVAC insert, output
Kanal 1
is switched off immediately, output
HLK
is switched
off after the set run-on time has elapsed.
Light Continuous off
Motions are not evaluated It is not possible to switch on via a 2-wire extension insert or
installation button.
o
Press
Á
button for less than 0.4 seconds or button (5) on the motion detector.
Light is switched off continuously. The red LED lights up.
i
With the HVAC insert, output
Kanal 1
is switched off immediately, output
HLK
is switched
off after the set run-on time has elapsed.
Switching off Off for 2 hours or Continuous off
o
Press
À
button, for function Continuous off press alternative button (5) on the motion
detector.
Automatic operation is switched on.
5/13
32576803
J:0082576803
03.05.2011
Light Management
Universal automatic switch 180° 2.20 m
