o
Carry out optional adjustment for use outdoors.
o
Switching on optional night light function
o
Configure dimming phase optionally in combination with dimming inserts.
o
Configure short time operation optionally in combination with switching inserts.
o
Set brightness threshold.
o
Set follow-up time.
7 Appendix
Remove empty batteries immediately and dispose of in an environmentally friendly
manner. Do not throw batteries into household waste. Consult your local authorities
about environmentally friendly disposal. According to statutory provisions, the end
consumer is obligated to return used batteries.
7.1 Technical data
Ambient temperature
-15 ... +45 °C
Protection rating
IP 20
Brightness setting
approx. 1 ... 200 lx (and day operation)
run-on time
approx. 10 s ... 60 min
Sensitivity
25 ... 100 %
Lockout time
approx. 0.3 ... 4 s
Installation height
1.10 / 2.20 m
Detection angle
180 °
cross walking range
approx. 12 x 6 m
walk to walking range
approx. 8×4 m
Short time operation
pulse duration
approx. 0.3 s
pulse stop
approx. 2.7 s
IR remote control
Battery type
1×lithium CR 2025
7.2 Troubleshooting
Motion detector does not switch on
Cause 1: The ambient brightness is greater than the set brightness value.
Set brightness value.
Cause 2: Motion detector does not detect any motions.
Increase sensitivity.
Switch on all sensors.
Switch on motion detector on 3-wire extension insert.
Cause 3: Off for 2 hours or Continuous off is activated
Switch on automatic mode.
Motion detector switches on without motions.
Cause 1: Presence simulation is activated. Motion detector switches to saved times.
Switch on automatic mode.
Cause 2: Interference sources in the detection area.
Remove interference sources if possible.
Reduce sensitivity.
Limit detection area.
11/13
32576803
J:0082576803
03.05.2011
Light Management
Universal automatic switch 180° 2.20 m
