Jung AS 1280-1 Series, Руководство по эксплуатации

Страница: 12 / 13

Motion detector constantly switches on and off during motion.
Cause 1: Test operation is switched on.
Cause 2: Short time operation is switched on.
Switch on automatic mode.
Motion detector switches off despite motion
Cause 1: The motion detector does not detect any motions.
Increase sensitivity.
Cause 2: Detection area is limited because a sensor was switched off.
Switch on all sensors.
Cause 3: Motion detector is switched off on 3-wire extension insert.
Switch on motion detector.
Cause 4: Run-on time limit is reached.
Motion detector does not switch off
Cause 1: Interference sources in the detection area, motion detector detects motions
constantly.
Remove interference sources if possible.
Reduce sensitivity.
Limit detection area.
Cause 2: On for 2 hours or Continuous on is activated.
Switch on automatic mode.
Cause 3: Night light function is switched on. The light stays on at 20% brightness.
Switch off night light function.
Motion detector does not respond to IR remote control, red LED does not flash.
Cause 1: IR remote control out of range.
Go closer to the motion detector.
Cause 2: Battery in IR remote control is empty.
Change battery (see back of the IR remote control)
Motion detector does not respond to IR remote control, red LED flashes, yellow LED
does not.
Cause : Motion detector is receiving an IR signal. Function or setting cannot be executed. The
motion detector is mounted on a concealed insert that does not support the function.
7.3 Accessories
Sealing kit for automatic switch 180° 2.20 m Art.-No.: AS 50 DS
12/13
32576803
J:0082576803
03.05.2011
Light Management
Universal automatic switch 180° 2.20 m