JUKI APW-895NE, Инструкция по эксплуатации

Страница: 80 / 256

− 64 −
No. Item
Setting range
/
Edit unit
Initial value
Back tack return at sewing end compensation
Back tack return at sewing end compensation is set.
* It is possible to set only when is set to the memory switch
selection.
−2.0 to 2.0
/
0.1mm
1.0mm
Selection of mode change-over button display in the pattern list
screen
Mode change-over button is displayed in the pattern list screen and
data of different mode can be selected.
- - -
Non-display Display
Cycle sewing coupling function
Odd-numbered pattern can be coupled to even-numbered pattern and
as many as 12 steps can be sewn.
Only combination of 1 and 2, 3 and 4, 5 and 6, 7 and 8, 9 and 10, 11
and 12, 13 and 14, 15 and 16, 17 and 18, and 19 and 20 can be cou
-
pled.
- - -
Coupling function
OFF
Coupling function
ON
Center knife lowering time
Center knife lowering time is set.
10 to 100
/
1
40
Center knife one-shot motion prohibition setting
With/without one-shot motion to properly cut the cutting position of cen -
ter knife on the side of the end of sewing is selected.
- - -
With one-shot
motion One-shot motion
prohibited
Compensation of turning of back tack stitches at the sewing start
This key is used to set a compensation value of the turning of back tack
stitches at the sewing start.
* It is possible to set only when compensates with pattern data.
–2.0 to 2.0
/
0.1mm
1.0mm
Clamp foot motor origin compensation
Origin of clamp foot motor is compensated.
−10.0 to
10.0
/
0.1mm
0.0mm