– 5 –
175mm
3
1
2
a
D, E
aMS-224EN-4530
aMS-224EN-6030
* The followng steps 3) through 7) are the re-
assembly procedure of the table.
3) Shft the table to adjust so that t laterally pro-
trudes from the end of the table stand by 75
mm. For the longtudnal drecton, also adjust so
that the table protrudes equally (approxmately 3
mm on each sde) from the end of table stand.
* If the table s not correctly postoned n the
longtudnal drecton, the throat plate auxlary
cover may not be removed.
4) Temporarily fix table fixing bolts
3
at two loca-
tons from the table stand sde.
5) Tghten screws
1
and
2
to mount the cover.
* If the cover and tapped hole do not algn, algn them
by movng the table.
* Tghten screw
2
after mountng the nut from the
undersde of the table.
6) Securely tighten the table fixing bolts at two
locatons from the table stand sde. (For refer-
ence: Tghtenng torque: 6 N•m)
7) After mounting the cover, attach the table fixing
bolt cover (accessory
a
) n poston.
9) Secure the operaton panel stoppers (accessory
D
) n the punched locatons at near sde of the
rght table usng wood screws (accessory
E
).
8) AMS-224EN-4530
Secure the swtch mount-
ng plate on the table
stand usng countersunk
head screw (accessory
B
). Then, fix the power
swtch usng sems screw.
AMS-224EN-6030
Secure the power swtch
at the punched locaton
on the lower rght part of
the table usng female
screw (accessory
c
).
3
2) Remove table fixing bolts
3
whch are mounted
at two locatons of the table stand.
B
c