Judo 8204016, Инструкция по установке и эксплуатации

Страница: 11 / 36

JUDO i-soft TGA 4 11
Installation
latching in the bayonet connection (see
fig. 3) and then tighten the four hexagon
socket head screws.
4.2.3 Installing the support ele-
ments
The bracket set (2 brackets with one pipe
clamp each) is screwed to the wall with 4
hexagon head screws.
Notes on installing the wall support (contain-
er support) are included in the correspond-
ing installation instructions.
4.2.4 Installing the two individual
softeners
The connection flange of the water softening
system is covered by a white protective cap.
This protective cap is secured using four
hexagon socket head screws M6x130.
– Loosen all four hexagon socket head
screws M6x130, but do not screw out
completely (bayonet connection)!
– Remove the white protective cap.
The profile of the profile flange seal must
point towards the parallel quick-assembly
kit. If this is not observed, water leaks may
occur This can result in water damage to the
building, furnishings and equipment.
– Raise the water softening system and
swivel approximately 30° in counter-
clockwise direction.
– Place on the parallel quick-assembly kit
so that the screw heads project through
the bayonet holes.
– Swivel the water softening system back
approximately 30° in a clockwise direc-
tion.
– Fully tighten the four M6×130 hexagon
socket head screws.
After installation of the water softening sys-
tems, push out the wall support until it touch-
es the cladding of the devices and the devic-
es hang vertically on the wall. Then tighten
the screws of the wall support.
Fig. 3: Bayonet function
Fig. 4: Support elements
Bracket
set
Parallel
quick-assembly kit
Rotary flange fitting
Wall support
Select the tightening torque (about
4 Nm) so that the seal is effective
and the water softening system is
not damaged or strained!