- 5 -
GENERAL
REMOVE ALL THE PARTS OF YOUR ROWER FROM THE CARTON AND PLACE THEM ON THE
FLOOR CAREFULLY. ASSEMBLING YOUR ROWER IS SIMPLE. FOLLOW THESE INSTRUCTIONS
CAREFULLY AND IT SHOULD TAKE YOU AROUND 20-25 MINUTES.
STEP 1
1) Secure with knob (105) & washer (26) on monitor support bracket (9) and front main
frame (1).
2) Cut the zip tie (82) between two monitor support bracket (9).
3) Cut the zip tie (82) between handlebar (65) and monitor support bracket (9).
3) Pull and slide the handlebar (65) and pass through the monitor support bracket (9) and
monitor bracket (11) carefully as shown.
4) Rotate the handlebar (65) to right 90
∘
and rest onto the handlebar stand (86) in position.
NOTE: Please follow the following step to assemble handlebar and avoid the chain to
drop off from the pivot shaft.
Use left hand to hold the chain (66) which is located on gear of pivot shaft and right hand
grips handlebar (65) through the monitor support bracket (9) & monitor bracket (11),
and place handlebar (65) on stand (86).
5) Put the top welded bracket of front stabilizer (6) with two wheel caps (28R/L) to bottom
four screw holes of front main frame (1) and tighten with four cap nuts (29), four spring
washers (114) and four flat washers (77).
6) Attach
“U” support bracket (2) to the end “U” welded bracket of front main frame (1) and
tighten with two allen head bolts (107), two flat washers (77), two spring washers (114)
and two nylon nuts (76).
NOTE: After finish whole product assembly, you can screw the pre-assembled level knob
(27) to adjust the whole product balance.
ASSEMBLY INSTRUCTION
Содержание Freedom Air Rower
Страница 17: ...16 EXPLODED DRAWING...