© 2017 JTECH Medical MN022_M
18
Registering a New Instrument For Use With Your Commander Echo Console
The Commander Echo Console comes with all instruments pre-registered for use; however, should you
purchase a new instrument at a later time, the following instructions can be used to add or remove a
instrument. If you need additional help registering new instruments with the Console, contact customer
service.
Instructions for registering a new instrument
1 .
Select “Settings” from the main menu.
2 .
Highlight “System.”
3 .
Press left/right until “Register” is displayed.
4 .
Turn on the instrument followed by pressing the Control Stick.
5 .
If the Console successfully registers the instrument then the Console will return to the settings screen.
Otherwise, once the instrument turns off, turn the instrument back on to try again.
6 .
To exit the registration without registering a instrument, hold left for 2 seconds.
Instructions for deleting a registered instrument
1 .
Select “Settings” from the main menu.
2 .
Select “Instrument.”
3 .
Select the instrument type for the instrument ID you wish to delete and press the Control Stick.
4 .
Highlight “System.”
5 .
Press left/right until “Info” is displayed, and press the Control Stick.
6 .
Press up/down until the device ID that you wish to delete is displayed.
7 .
Hold the Control Stick until the Console returns to the settings screen.
Instructions for changing the RF channel
1 .
Select “Settings” from the main menu.
2 .
Highlight “System.”
3 .
Press left/right until “Scan” is displayed, and press the Control Stick.
4 .
Wait approximately 10 seconds, when the Console is finished it will have set the best channel found at the
time.
Instructions For Multiple Commander Echo Consoles
1 .
After turning on a Console enter the “Test” menu to connect any instrument.
2 .
Next turn on an additional Console then follow the instructions for “changing the RF channel.
3 .
Connect to an instrument.
4 .
Repeat as necessary for each additional system
This will insure that each Console does not interfere with any other Console at your location. A total of 12
systems can be setup to operate without interfering with each other. The 12 system limit does not account
for possible interference from wireless systems other than Commander Echo.
Displaying Instrument Battery Voltage
1 .
Select “Settings” from the main menu.
2 .
Select “Instrument.”
3 .
Select the instrument type for the instrument ID you wish to display battery voltage.
4 .
Highlight “System.”
5 .
Press left/right until “Info” is displayed, and press the Control Stick.
6 .
The Console will now attempt to connect to the selected instrument. Press the “On” button for the
corresponding instrument followed by pressing the Control Stick on the Console to establish connection.
7 .
Once connected the Console LCD will show the instrument’s serial number, revision, battery voltage and
calibration information.
