ASSEMBLY OF THE ELECTRIC SCOOTER
The ideal place to ride and then park the scooter is the garage or shed. Avoid leaving scooters on
indoor carpets, floors or stairs.
Assembly :
1.
Open the box, take out the scooter and the front wheel
2.
Place the scooter on its kickstand to attach the front wheel to the handlebar shaft as
shown on the picture below. To do this, hold one side with the wrench and tighten the other
side with an Allen key.
3.
To unfold the scooter, begin by pressing down on the folding handle with one hand,
while gently pulling up on the handlebars with the other. The handlebar will snap into place
and will not move when secured properly.
4.
Loosen the handlebar clamp and raise the handlebar to the desired height, being
sure the pole snaps into place. Then tighten the clamp securely.
5.
To attach the handlebars on each side of the T-bar, first loosen the top handlebar
clamp then slide each handlebar into the T-bar being sure they snap into place and are in t
he right direction for riding. Finish by pressing down the clamp lever securely.
Battery :
WARNING
Do not allow the batteries on your scooter to fully discharge, as this may damage them.
1. Make sure the scooter is off (charging position)
2. The charging socket is located on the side. (See photo below)
3. Locate your battery charger. Find the plug of the charger that has a single pin plug and
plug it into the scooter.
4. Next, plug the charger into a wall outlet.
