- 15 -
Field Configurators HARTConf, LHPConf for Transmitters with HART or LHP Communication and HART-USB Modem
Configuration changed
- some parameter was changed since last deletion of attribute
Cold start
- first command since instrument switch on
More status available
Analogue output current fixed
- forced output current does not match with measured value
Analogue output saturated
- analogous output is at the beginning or end of the range
Variable (not primary) out of limits
- the variable is out of maximum range limits
Primary variable out of limits
- the primary variable is out of maximum range limits
4.4. Operation and maintenance
In case the instrument is installed correctly, the operator
can read setting and measured values using
a communicator. He may change setting of the
instrument only if a sudden change of the output current cannot
cause any failure of the technological equipment or regulation
(switch the possible regulator to manual control)!
Attention!
The internal power supply may be switched
on only if the connected instrument is not supplied from
other power source!
The instrument does not need any maintenance.
5. Product specifications
5.1 Technical specifications
Supply voltage:
battery 9 V (6LR61, 6F22) or accumulator 8.4 V
USB
Ambient temperature:
-20 to +50 °C
Housing:
IP40, connectors IP00
Humidity:
0 to 80 % r.v.
Connection of the HART cable:
BNC connector, negative pole of voltage for
a transmitter is on the connector jacket
Dimensions:
112.5 x 65 x 32 mm
Material of case:
Black ABS
Weight:
85 g without battery
Working position:
Arbitrary
HART / LHP interface
Communication protocol:
HARTConf
HART, rev.5, LHP
LHPConf
LHP
Transmitter supply voltage:
min. 12 V
SS
/ 22 mA, switch-on / switch-off /
energy saving mode
USB interface
USB standard:
USB 1.1
Max. power demand from USB interface:
With transmitter supply:
140 mA
Without transmitter supply:
30 mA
Battery charging:
100 mA
5.2 Supplementary parameters
Electric strength of insulation between the HART / LHP
interface and USB interface:
1000 VAC / 1 min. (test)
Typical times of operation in different working modes:
Operated from the accumulator with permanent transmitter
supply:
2 hours
Operated from a primary battery with permanent transmitter
supply:
4 hours
Operated from the rechargeable battery without transmitter
supply:
8 hours
Operated from a primary battery without transmitter supply:
15 hours
Operated from an USB port:
unlimited
Charging time of rechargeable battery through an USB
port:
10 hours
Indication of battery charge:
Continuous, with a battery charge symbol on the
display
Indication of transmitter supplying switch on:
Symbol of a battery on the display
Electromagnetic compatibility:
Emissions and resistance acc. to EN 61326-1
(industrial environment)
6. Standards and marking
6.1 Standards
Electromagnetic compatibility:
Emission and resistance according to EN 61326-1
(industrial environment)
The transmitter is designed and made in compliance with
following standard:
EN 61010-1
6.2 Marking and type tag information
Standard verion:
HARTConf, LHPConf
type number
S/No:
serial number
Czech Republic
country of origin
logo JSP, s.r.o.
www.jsp.cz
website address
