JR Robinson R22 Скачать руководство пользователя страница 47

Страница: 47 / 76

–

2. JR XP8103/XP8103DT Systems

The following activation and setup procedure should be used for
all JR XP8103 and XP8103DT (Digital Trim) systems.

Note: Some early XP8103 systems will require the activation

of the CCPM software through the Horizon service
center. It’s easy to identify if your system has the CCPM
function activated by identifying if the “SWASH TYP”
function appears in the system mode as shown in
section A below. Please refer to section A to access the
system mode.

Prior to activating the CCPM function, it is first suggested that the
Data Reset function be performed to reset the desired model
number to be used back to the factory default settings.

Caution: Prior to performing the Data Reset function, it will

be necessary to select the desired model number to
be used.

A) Press the Up and Down keys simultaneously while

turning the power switch on to enter the system mode.
Next, press the Up or Down keys to move the cursor to
the Model Select function. Press the Up and Down keys
simultaneously to enter the Model Select function. Select
the desired model number to be used, then press the
Clear key to reset the current model to the factory default
settings. Press the Up and Down keys simultaneously to
exit the Model Select function.

B) Press the Up or Down keys to move the cursor to the

Swash Type function, then press the Up and Down keys
simultaneously to access the Swashplate Type function.

Note: If the Swashplate type function is not present, it can be

activated by the Horizon Service Center. Please call
for details.

Press the Up or Down keys until “3servos 120°” appears on the
screen. Press the Up and Down keys simultaneously two times
to exit the Swashplate Type function and the system mode.

C) Turn the power switch on, then press the Up and Down

keys simultaneously to enter the function mode. Press
the Up key until “Swash Mix” appears on the screen.

Once this has been completed, it will be necessary to
change the value of the Pitch function from the factory
default setting of 60, to a value of -50 using the + and - keys.

D) Press the Up key until “Rev. Sw” (Servo Reversing)

appears on the screen. Next, reverse channels 1, 2, and 4
by moving the cursor with the CH key, then pressing the
+ or - keys.

Press the Up key until “TRVL ADJ.” (travel adjust)
appears on the screen. Adjust the values as shown using
the Channel key to move the cursor, and the + and - keys
to set the value. Press the SEL key to access the pitch
channel values and set as indicated. Please note that the
required travel values will vary based on the type of servo
selected. Please also note that the throttle travel values
may vary based on the type of engine used. This value can
be fine-tuned once the throttle linkage has been installed.

Note: The travel values shown for the rudder function are

for use with Piezo type gyros, like the JR NEJ-900,
NEJ-400, NEJ-450, and NEJ-3000 type gyros. If a
conventional mechanical type gyro is used (JR 120,
130, etc), then the travel values of the rudder channel
will need to be reduced to approximately 100%.

CCPM SOFTWARE ACTIVATION AND INITIAL ADJUSTMENT, continued

[SYSTEM M.]

• INFO-DISP

• Model SEL

• MDL Name

• Type SEL

• MDL Reset

• MODULAT

• TRANSFER

• INPUT SEL

• SWASH TYP

[MDL Reset]