JR Robinson R22, Руководство по сборке

Страница: 46 / 76

1. JR 10 Series Systems
The following activation and setup procedure should be used for
all JR PCM10, 10S, 10SX, 10SXII, and 10X systems.
Prior to activating the CCPM function, it is first suggested that a
Data Reset function be performed to reset the desired model
number to be used back to the factory default settings.
Caution: Prior to performing the Data Reset function, it will be
necessary to select the desired model number to be
used. Access the model select function (code 84)
and select the desired model to be used.
Setup Procedure
A) Access the Data Reset function (code 28) once the
correct model number has been established. Next, press
the Clear key to reset the current model. Press the Enter
key to exit the Data Reset function.
B) Access the Swash Type function (code 65). Next, press
the SEL key until “3 SERVOS” (120°) appear on the
screen. Once this is complete, it will be necessary to
change the value of the Pitch function from the factory
default setting of +60, to a value of -50 using the + and -
keys below the pitch value. Press Enter to exit the Swash
Type function.
C) Access the Servo Reversing function (code 11). Next,
reverse channels 1, 2, and 4 by pressing the desired
channel number. The screen should appear as shown.
Press Enter to exit the Servo Reversing function.
D) Access the Travel Adjust function (code 12) and adjust
the servo travel values as shown. Please note that the
required travel values will vary based on the type of servo
selected. Press Enter to exit the Travel Adjust function.
Note: The travel values shown for the Rudder function are
for use with Piezo type gyros, like the JR NEJ-900,
NEJ-400, NEJ-450, or NEJ-3000 type gyros. If a
conventional mechanical type gyro is used (JR 120, 130
etc.), then the travel value of the rudder channel will
need to be reduced to approximately 100%.
CCPM SOFTWARE ACTIVATION AND INITIAL ADJUSTMENT
[DATA RESET]
MODEL 1 SPCM
CLEAR ENTER
[SWASH TYPE]
3SERVOS(120•)
FXP AILE ELEV PITCH
[NH +60% +60% -50%
ENTER
SEL ACT + –
CL
+ –
CL
+ –
CL
[REVERSE SW]
REVERSE
NORMAL
ENTER
1 2 3 4 5 6 7 8 9 10
[TRAVEL ADJUST]
THRO AILE ELEV RUDD
H130% L120% D120% L150%
L130% R120% U120% R150%
PAGE
+ –
CL
+ –
CL
+ –
CL
+ –
CL
[TRAVELADJUST]
PITCH
+120%
-120%
+ –
CL
+ –
CL
+ –
CL
[CLEAR]
SELECT 3 SERVOS (120°)
Digital Servos/Super servos
Throttle travel values may vary
depending upon engine used.
[TRAVEL ADJUST]
THRO AILE ELEV RUDD
H110% L100% D100% L150%
L110% R100% U100% R150%
PAGE
+ –
CL
+ –
CL
+ –
CL
+ –
CL
[TRAVEL ADJUST]
PITCH
+100%
-100%
+ –
CL
+ –
CL
+ –
CL
Standard Servos
Throttle travel values may vary
depending upon engine used.
46
JRP9012.46 Robinson R22 Manual 10/6/00 5:06 PM Page 46