Joyner TROOPER T2, Руководство пользователя

Страница: 92 / 205

92
damages.
2.4.3. Use a cl6 gauge to adjust the
radial clearance of the crankshaft; tighten
the bolts of bearing bush cover with
specified torque.
[Torque]
70±3.5N.m
Attention
Tighten the bolts of the crankshaft
bearing cover in three times to the regulated
value, in the sequence as shown in the right
figure. Attention: Don’t turn the crankshaft after
tightening ,because of the clearance gauge.
2.4.4. Remove the bearing cover and measure
the maximum width of the spacing. If it
goes beyond the limit, replace the bush.
[Benchmark]
:0.025-0.069mm
[Limit]
:0.10mm
2.4.5. Remove Main bearing cover, Crankshaft,
Crankshaft bush, Thru st washer
Attention:
tighten the bolts fixing bearing cover
according the order show as right figure.
2.5.
Disassembling of connecting rod assembly
of the piston
2.5.1. Use the piston ring pliers to remove the
primary ring, the secondary ring and the
oil ring
Attention
Do not mix up the pistons and piston
rings for each unit of assembly.
2.5.2. Use SST to remove the piston, connecting
rod and piston pin
Clearance gauge