Joyner TROOPER T2, Руководство пользователя

Страница: 61 / 205

61
Specifications and model of clockwise pulley
Model
ＥＦ
Item
ＧＬ、ＺＬ、ＧＳ、ＺＳ
Diameter of camshaft
timing gear
（
mm
）
φ 110.7
+0.1
-0.2
Diameter of crankshaft
timing gear
（
mm
）
φ 54.65
+0.7
-0.13
Baffle of crankshaft timing gear
Check to see if there is any deformation
Standard size of crankshaft timing gear
：
3.
Installation
3.1.
Installation of crankshaft timing gear
3.2.
Installation of timing belt
3.2.1. On the upper thrust point of the first
cylinder Compression Place the
camshaft timing gear around the front end
of the air exhaust camshaft so as to make the
positioning groove on the gear be aligned with
the positioning pin on the end surface of the
camshaft. Then use screws to fix the clockwise
gear, with the torque of 100 ± 5N.m.
3.2.2. Make sure that the punched mark on the
crankshaft clockwise pulley is aligned with
the mark of the oil pump.
3.3.
Install the tensioner
3.3.1. Adjust the tension of the timing belt As
shown in the figure, make the space
between the edge of the stretching wheel
and the water pump case arc to be about
8mm;Tighten the bolt of the stretching
wheel with a torque of 25 ± 3N.m. Use a
screwdriver to swing the stretcher toward
the right..
Wide 28.6mm