35
130102- 1 GF 370 DV MV 2/22
4. Push in Valve Control knob slightly and turn clockwise
to “OFF”.
NOTE: Knob cannot be turned from “PILOT” to
“OFF” unless the knob is pushed in slightly. Do not
force.
5. Wait five (5) minutes to clear out any gas. If you then
smell gas, STOP! Follow “B” in the safety information
above on this page. If you do not smell gas, go to the
next step.
6. Push in Valve Control knob slightly and turn
counter-clockwise to “PILOT”.
7. Push in control knob all the way and hold in.
Immediately light the pilot by triggering the spark
ignitor (push the red button repeatedly) until pilot
lights. Continue to hold the control knob in for
about one minute after the pilot lights. Release knob
and it should spring
back. The pilot should
remain lit. If it goes out,
repeat Steps 5 through
7.
• If knob does not
return when released,
stop and immediately
call your service technician or gas supplier.
• If pilot will not stay lit after several tries, turn the
control knob to OFF and call your service technician
or gas supplier.
8. Turn Valve Control knob counter-clockwise to
“ON”.
9. Set the BURNER switch to “ON”, or set
thermostat (if used) to desired temperature.
1. Place BURNER switch in” OFF” position. The pilot
will remain lit for normal service.
FOR YOUR SAFETY, READ BEFORE LIGHTING.
LIGHTING INSTRUCTIONS
TO TURN OFF GAS TO THE APPLIANCE:
LIGHTING INSTRUCTIONS
WARNING:
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY
RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE.
A. This appliance has a pilot which must be lit by hand.
When lighting the pilot, follow these instructions
exactly.
B. BEFORE LIGHTING, smell all around the
appliance area for gas. Be sure to smell next to the
floor because some gas is heavier than air and will
settle to the floor.
WHAT TO DO IF YOU SMELL GAS:
• Extinguish any open flame.
• Open windows.
• Do not light any appliance.
• Do not touch any electrical switches.
• Do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s
phone.
• If your gas supplier cannot be reached, call the fire
department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, do not try to repair it. Call a qualified
technician. Force or attempted repair may result in a
fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
1. STOP! Read the safety information above.
2. Set the BURNER ON/OFF switch to “OFF”, or set the
thermostat to lowest setting (if used).
3. Confirm that the gas supply line shut-off valve is open.
Pilot Assembly
Control
Knob
OFF
PILOT
ON
Control Valve
2. For complete shutdown, depress the Valve Control Knob
and turn clockwise to “OFF”. Do not force.