21
130102- 1 GF 370 DV MV 2/22
1
2
3
4
5
6
2. Install the Adaptor Plate (#1) on the burner by
engaging it with the two burner pins (A) at the
arrows shown above.
3. Loosely spread a layer of ember stones around the
perimeter of the burner plate.
1. Refer to the Contents list and lay out the
logs to identify the parts as shown. The logs
engage with steel pins on the Adaptor Plate
(1). Identify pin engagement holes in the
underside of logs 2, 3, and 4. Engagement
holes are in the lower ends of logs 5 and 6.
4. Engage the holes in the bottom of Rear Log
(#2) with the two steel pins (B) at the left rear
corner of the burner plate.
5. Engage the two holes in the bottom of the
Center Log (#3) with the two burner plate pins
(C).
6. Engage the holes in the Front Log (#4) with
the two pins (D) in the right front corner.
A
B
C
C
D
E
PIN IDENTIFICATION
A
LOG IDENTIFICATION
2
3
4
7. Engage the hole at the lower end of the Left
Vertical log (#5) with left Adaptor pin “A”. See
Step 2 photo.
Rest the right fork of the log upon the Center log
and lean the upper end against the rear wall of the
firebox as shown.
5
Beachfire Logset
1. Log Retainer
22664192
2. Left Rear Log
226843
3. Center Burner Log 226849
4. Right Front Log
226845
5.Left Vertical Log
226850
6. Right Vertical Log 226851