Jonix duct 70MIC2C, Руководство по эксплуатации и обслуживанию

Страница: 19 / 32

19
JO NIX
duct
03
05
06
04
7.2.1 Cleaning the Ionising Tubes
Fig. 03: Switch off the ionising module
JO NIX
duct
by turning the luminous On/
Off switch to O.
Remove the plug connected to the mains
and other plugs from the
JO NIX
duct
module.
Fig. 04: Unscrew the four screws which, by
means of the brackets, secure the module
to the wall and pull it out by the handle.
Fig. 05: Gently unscrew the tubes, using
the green plastic base. If you have trouble,
first pull off the outer mesh.
Fig. 06: Pull off the outer mesh from the
tube if you have not already done so in the
previous point.
Clean the glass using a damp cloth.
If the operation is difficult
to perform, pull slightly the
earthing spring so that it is not
in contact with the surface of
the tube.
If this is difficult to do, turn the
mesh around the glass while
pulling to remove it.
Check that the tube is in good conditions: there must not be any cracks or other damage;
otherwise it must be replaced. As soon as you notice a whitish layer on the perforated
metal plate inside the glass it means that the ionising tube needs replacing.
The tubes must usually be replaced within 18 months of use.