Jonix duct 70MIC2C, Руководство по эксплуатации и обслуживанию

Страница: 14 / 32

14
JO NIX
duct
WARNING!
Using power supply that does not meet the requirements requested by the device
could resolve in damaging the device or part of it.
• The electrical connections must be carried out following the instructions provided in this
manual.
• Make sure that voltage and frequency of the electric line correspond to those provided on
the name plate.
• The electrical mains of the
JO NIX
duct
device must be used for the device only, there must
be no other devices powered by the same power line. Do not use adapters, power strips and/
or extension cords.
• Make the connection with cables with a suitable cross-section and in compliance with local
standards.
• The installer must see to it to assemble the device as close to the power disconnector as
possible, according to standards in force and as far as necessary to protect the electrical parts.
6.5 ELECTRICAL CONNECTIONS
ATTENTION! BEFORE STARTING ANY OPERATION, MAKE SURE THAT THE MAIN
POWER SUPPLY IS DISCONNECTED!
The
JO NIX
duct
device leaves the factory fully wired. It only needs to be plugged into the electric
mains, 230V/ ~1 / 50Hz + PE. Power must be brought to the socket installed on the module by
an IEC 60320 C13 type plug. A residual current device must be installed upstream according to
standards in force. The socket on the panel is equipped with a fuse.
6.6 ELECTRIC POWER SUPPLY
The ON/OFF switch indicates when the device is powered.
ATTENTION!
Using the supplied rope for the link to the net or provide one of equal section
always composed by F,N and T. Before making any connections, make sure the
mains voltage complies with what is shown on the label.
It has also to be provided:
• A four polar linking rope on alarm contact not in tension for the takeover of the state signal of
the device.
• A six polar linking rope on signal contact of alarm reset and of the comunication serial line.
Remote contact for module activation / deactivation.
The plugs of these contacts are provided with the form.