Jolimark TP820, Руководство пользователя

Страница: 23 / 48

TP820 User’s Manual
- 20 -
The method is that press
FEED
button and power on the printer, the
ERROR
indicator blinks once with
two beeps. Go on holding the button for about a second, loosen it after the
ERROR
blinks once again
with a beep. Turn off the printer when you want to exit this print mode.
3.4 Restoring Factory Printer Settings
The function is to clear the settings stored in the printer and to restore the factory settings for
correlative parameters.
The method is that press
FEED
button and power on the printer, the
ERROR
indicator blinks once
with beeping twice at the same time. Do not loosen the button until the
ERROR
indicator blinks once
with beeping once in about one second. At this time, turn off the printer and the function takes effect.
3.5 Setting Slip Stitch
If needed, Slip Stitch is used to upgrade printer firmware or it should be closed in normal working
condition. When to upgrade, pull out the Slip Stitch Cap after the printer is turned off, press
FEED
button and power on again, the
ERROR
and
PAPER OUT
indicator blinking once at the same time,
which indicates that the printer enters into the online-upgrade mode. Loosen the button and then use
the computer software equipped with the printer to upgrade. Turn off the printer after finishing
upgrading, plug Slip Stitch Cap and then the printer can be working normally.
Note: Do not change the Slip Stitch without any permission of the factory, or the printer can
not work.
3.6 Online-aptitude Parameter Settings
TP820 supports the function of online-aptitude parameter settings, which can be set in the PC with
the driver installed in. The parameter settings of serial interface can be modified in the driver’s
property page.
The concrete setting steps are shown as follows:
1. Make sure that the host and the printer are connected with a cable and both the host and the
printer are turned on, the printer should be online as well.
2. Click “Start” → “Settings” → “Printers”.
3. Right click “TP820”, select “Properties”.
4. Click “Printer settings” in the property page.
When Plugging Into
When Pulling Out
Slip Stitch Cap
Slip Stitch
Fig 3-2 Setting slip stitch