Johnson Outdoors MINN KOTA 1810371, Руководство пользователя

Страница: 4 / 10

4 | minnkotamotors.com
©2020 Johnson Outdoors Marine Electronics, Inc.
e. To install the Direct Mount Angle bracket to the
Transom, use the Mounting Hardware Kit 2994943
provided with the Raptor. Take each of the four
3-1/2" Stainless Steel Hex Head Cap Screws (Part
#2383421) and place one Flat Washer (Part
#2371758) on them. Apply anti-seize (Item #10) to
the hardware. The Hex Head Cap Screws will pass
thought the Flat Washers, into the Direct Mount
Angle Bracket and through the Drilled locations
on the Boat.
f. Place a Fender Washer (Part #2371759) on the end
of each Screw on the inside of the Transom and then
secure each with a Flange Nut (Part #2353102).
Apply anti-seize to the threads before tightening.
Tighten the screws with a 9/16" Box End or Socket
Wrench. Do not over-tighten. Tighten to 20 ft-lbs.
4
4e 4f
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Applying an anti-seize may help prevent seizing.
Transom Transom
Flange
Nut
Stainless Steel Hex Stainless Steel Hex
Head Cap Screws Head Cap Screws
Direct Direct
Mount Mount
Angle Angle
Bracket Bracket
Direct Direct
Mount Mount
Angle Angle
Bracket Bracket
Flat Flat
Washers Washers
NOTICE:
An alternate option is to mount the bracket, by
passing the Hex Head Cap Screw with the Fender Washer
from the inside of the transom to the outside. Pass the
Screws into the Drilled Locations. Then pass them into the
Direct Mount Angle Bracket. Secure on the outside of the
boat with the Flat Washer and Flange Nut.
ITEM(S) NEEDED
#10 x 1
Fender
Washer
5
5g
5h
Transom Transom
Transom Transom
Mounting
Bracket
Flat Washers
Hex Head
Cap Screws
Direct Mount Direct Mount
Angle Bracket Angle Bracket
Direct Mount Direct Mount
Angle Bracket Angle Bracket
Slotted Holes Slotted Holes
Slotted Holes Slotted Holes
Raptor
g. With the Direct Mount Angle Bracket secured to
the Transom, take the Raptor and align the Raptor
Mounting Bracket with the Slotted Holes on the
Direct Mount Angle Bracket. Notice that the holes
are slotted so that the Raptor can be adjusted along
the slots for the final installation.
h. With the help of a second person, hold the Raptor in
place to install the mounting hardware. Take the four
1-1/4 Stainless Steel Hex Head Cap Screws (Item
#8) and four of the Stainless Steel Flat Washers
(Item #4). Place a Washer on the end of each
Screw and then apply anti-seize to the threads
of each Screw. Insert each Screw into the Raptor
Mounting Bracket and then into the Direct Mount
Angle Bracket.
ITEM(S) NEEDED
#4 x 4 #8 x 4