Johnson Outdoors MINN KOTA 1810371, Руководство пользователя

Страница: 2 / 10

2 | minnkotamotors.com
©2020 Johnson Outdoors Marine Electronics, Inc.
Correct Incorrect
Raptor Raptor
Raptor Raptor
Raptor Raptor
Range of Motion Range of Motion
3 3
4
2" 2"
Minimum Minimum
4" Minimum 4" Minimum
Hull directly
below Raptor Hull directly below Raptor
Outboard Motor Outboard Motor
Range of Motion Range of Motion
Bottom Edge Bottom Edge
of Raptor of Raptor
Bottom Bottom
Edge of Edge of
Raptor Raptor
4" Minimum 4" Minimum
2" 2"
Minimum Minimum
2" 2"
Minimum Minimum
2" 2"
Minimum Minimum
Slotted Slotted
Mounting Mounting
Holes Holes
Slotted Slotted
Mounting Mounting
Holes Holes
Outboard Outboard
Inboard Inboard
3. Raptor to Hull Clearance - The bottom edge of the Raptor should
never be less than 4” above the hull directly below the Raptor to
prevent spray and drag conditions.
4. Raptor to Engine Clearance - When selecting a mounting location,
make sure that no interference exists between the Raptor and
your engine during normal operation. Once you have selected your
mounting location, trim the engine all the way up and all the way
down, and steer the engine fully to the left and right to confirm
proper engine clearance. Ensure there is a minimum of two to three
inches of clearance from any point on the Raptor in all states of
stow and deploy.
5. Outboard Slotted Mounting Holes - When mounted on either the
Port or Starboard side, the bracket should always be oriented to
face away from the engine, with the slotted holes facing away from
the transom.
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Wetting the screws or applying an anti-seize may help
prevent seizing.
Raptor Raptor
Raptor Raptor
Installing the Direct Mount Angle Bracket
a. Review the Mounting Considerations to determine
if it is acceptable to complete a direct mount of the
Raptor Direct Mount Angle Bracket. If acceptable,
position the Direct Mount Angle Bracket (Item
#2) at the selected location. Make sure that the
Slotted Mounting Holes are positioned away from
the Transom and facing Outboard. With the bracket
level and in place, mark all four Mounting Holes
with an awl or similar marking tool.
1
1a
ITEM(S) NEEDED
#2 x 1
Transom Transom
Direct Mount Direct Mount
Angle Bracket Angle Bracket
INSTALLATION
Mounting Holes Mounting Holes
Slotted Slotted
Mounting Holes Mounting Holes
Mounting Holes Mounting Holes
Marked Marked
Locations Locations
Outboard Outboard
NOTICE:
It is recommended to have a second
person help with installation.