• Protective shell
• 6-pin RJ-12 connector cable
• Lanyard
• Installation Instructions
•
Mobile Access Portal Gateway Quick Start Guide (Part No. 24-10737-16)
Parts Included
• MAP Gateway
• Field bus adapter
• Mounting bracket (with locking screw)
•
Mobile Access Portal Gateway Quick Start Guide (Part No. 24-10737-16)
Special Tools Needed
To use the MAP Gateway, you need a mobile device (tablet or smartphone) or computer (laptop or
desktop) that supports Wi-Fi.
If the unit is permanently mounted to a vertical surface without a DIN rail, you need screws to
mount the unit. The specific screw types depend upon the surface to which the unit is mounted.
The screw holes on the MAP Gateway can accommodate M3.5 and #6 screws.
Use of the mounting bracket locking screw requires a T15 Torx screwdriver.
Portable Use
When used as a portable unit, the MAP Gateway should be housed in the supplied shell. During use,
the unit can be temporarily hung on nearby equipment using the supplied lanyard.
CAUTION
Risk of Personal Injury.
Do not wear or hold the MAP Gateway during use, and only use or install the MAP Gateway at locations
where there is at least 20 cm between the built-in antenna and all persons. Failure to do so may result
in minor or moderate personal injury.
CAUTION
Risque de blessure.
Ne pas porter ou soutenir l'MAP Gateway durant son utilisation et utiliser ou installer l'MAP Gateway
uniquement à un emplacement offrant une distance minimum de 20 cm entre l'antenne intégrée et
toute personne. Le non-respect de cette précaution risque de provoquer des blessures légères ou de
gravité modérée.
7
Mobile Access Portal Gateway Installation Guide
