Figure 3: Positioning the Bracket on a DIN Rail
3. Hang the bracket on the DIN rail by the hooks at the top of the DIN rail channel (on the back of
the bracket), and position the bracket snugly against the DIN rail.
4. Push the bottom DIN (mounting) clip inward to secure the mounting bracket on the DIN rail.
5. Place the MAP Gateway unit in the bracket and secure it with the locking screw.
Wall Mounting
The bracket may be mounted using screw holes on the back of the bracket (so that the back of the
unit is flush with the mounting surface), using the screw holes on the side of the bracket, or using
the holes in the DIN rail clips. This orientation helps accommodate on-site constraints. Screw hole
locations are illustrated in Figure 7, Figure 8, and Figure 9.
The screw types needed to mount the unit depend upon the surface to which the unit is mounted.
The screw holes on the MAP Gateway can accommodate M3.5 and #6 screws.
For information on location considerations for maximizing signal strength, see the
section.
Figure 4: Sample Permanent Mounting, Back-side Screws
11
Mobile Access Portal Gateway Installation Guide
