Johnson Controls PCA3613, Руководство по установке

Страница: 17 / 30

Table 3: Terminal blocks, functions, ratings, requirements, and cables
Terminal block
label
Terminal
label
Function, ratings, requirements Determine wire size
and maximum cable
length
ICOM n Universal Input Common for all
Universal Input terminals
Note: All Universal ICOM n terminals
share a common, which is isolated
from all other commons, except
the SA bus common. One common
screw terminal point is provided
for every two input screw terminal
points.
Same as (Universal)
IN n
Binary Input - Dry Contact Maintained
Mode
0.01 second minimum pulse width
Internal 18 V. 3k ohms pull-up
IN n
Binary Input - Pulse Counter/
Accumulator Mode
0.01 second minimum pulse width
(50 Hz at 50% duty cycle)
Internal 18 V. 3k ohms pull-up
BINARY
(Inputs)
ICOM n Binary Input Common for all Binary
Input (IN) terminals
Note: All Binary ICOM n terminals
share a common, which is isolated
from all other commons.
See Guideline A in
Table 4.
ANALOG
(Outputs)
OUT n Analog Output - Voltage Mode (0–10
VDC)
10 VDC maximum output voltage
10 mA maximum output current
Required an external load of 1,000 ohms
or more.
Note: The Analog Output (AO)
operates in the Voltage Mode
when connected to devices with
impedances greater than 1,000
ohms. Devices that drop below 1,000
ohm may not operate as intended
for Voltage Mode applications.
See Guideline C in
Table 4.
17 PCA3613 Advanced Application Programmable Controller Installation Instructions