Wall mount applications
To mount the network engine on a vertical surface:
1. Mark the location of the four wall mount feet on the wall using the dimensions in Figure 4 and
an orientation shown in Figure 5, or hold the network engine up to the wall and mark the hole
locations.
Figure 4: Mounting screw hole dimensions, mm (in.)
2. Drill holes in the wall at the marked locations.
3. Insert appropriate wall anchors in all four holes (if necessary) and insert the screws into the
top two holes. Leave enough space between the wall surface and the screw head for the wall
mount feet.
4. Hang the network engine on the screws with the top wall mount feet for horizontal wall mount
applications. Hold the network engine in place for vertical application.
Note:
The wall mount feet are designed to make mounting easier. When the network
engine is wall mounted in the horizontal orientation, you can hang the network engine on
the screws with the upper two mount feet (Figure 5).
5. Insert the screws into the lower two wall mount feet and holes and carefully tighten all of the
screws.
Important:
Do not overtighten the mounting screws. Overtightening the screws can crack
the network engine wall mount feet or housing.
DIN rail mount applications
To mount the network engine on DIN rails:
1. Mount two DIN rails horizontally, so they are 125 mm (4.9 in.) apart on centers (Figure 3).
2. Snap the DIN clips on the bottom of the network engine to the outward position.
5
NAE55/NIE55 Installation Guide
