Johnson Controls NAE55 Series, Руководство по установке

Страница: 15 / 36

Figure 13: KNX/IP interface router
3. For a single KNX line, wire from the red and black terminals on the gateway to the devices. For
multiple KNX lines, wire from the red and black terminals on each gateway to the devices on
the same KNX line.
Note: Specific cabling can vary depending on the topology and site. See Wiring
considerations and guidelines for network integrations .
4. Wire each KNX gateway to its own dedicated power supply on the KNX line.
Connecting other third-party devices
The network engine supports several other third-party devices. Refer to the following documents
for information about how to connect the network engine to these devices:
• C•CURE-victor:
NAE Commissioning for C•CURE-victor Integration Application Note (LIT-12013151)
• Simplex FACU: NAE Commissioning for Simplex Fire System Integration (LIT-12013060)
• Cree SmartCast Lighting Control: Metasys System Commissioning for CREE Digital Lighting Systems
Integration (LIT-12013152)
• Molex Lighting Control: Metasys System Commissioning for Molex Digital Lighting Systems
Integration (LIT-12013153)
Connecting the power source
Connect the 24 VAC supply power wires from the transformer to the removable power terminal
connector on the network engine (Figure 14). The connections are HOT and COM (common).
15 NAE55/NIE55 Installation Guide