Johnson Controls KT-IP, Руководство по установке, Страница: 25 / 36

21
DN1670-2201
IP Link Installation Manual
8. Click the Protocol ( UDP or TCP )
9. Change the Port number, if required.
Note: The port number must only be changed when you have more than one IP Link at the same
remote site.
10.Click OK .
11. Repeat the procedure for each IP Link at this site.
Confirming IP Link Communication with the Gateway
The IP Link should begin communicating with the Gateway in a few minutes. To confirm that they are
communicating, please verify the following:
12.Verify that the IP Link heartbeat pattern LED is flashing 1 quick flash per second as in
Table 2 on
page 5 .
13.Verify communication between the new IP Link and the Gateway. From the EntraPass workstation
Operation menu, click Site and then click the Gateway from the Gateway List .
Note: For the EntraPass Special Edition application, there is no Gateway List selection.
The Communication status must read as follows: IP Link communication OK .
If the communication status does not indicate IP Link communication OK, check the descriptions
for the other messages:
• IP Link communication unknown : The IP Link is starting up.
• IP Link communication failed : The IP Link has failed to report to the Gateway.
• Failed to reach IP Link : The Gateway is not receiving the IP Link confirmation through the
communication port 18801.
- Check if network cable is connected to RJ-45 connector on IP Link.
- Verify configuration port number if there are more than one IP Link at the remote site.
- Verify port forwarding assignments at both sites, see Table 11 on page 18 and Table 12 on
page 19 .
- Validate the addresses (IP or DNS) of the Gateway in EntraPass and the IP Link.