John Lewis JLBIGGH 704, Инструкция по эксплуатации

Страница: 26 / 28

26
Something Not Something Not
Something Not Something Not
Something Not W W
W W
Working orking
orking orking
orking
SSSSSolutions olutions olutions olutions olutions
Have the fuses replaced.
Reset the switches.
Touch the main On/Off Control .
Open the tap.
Purchase a new bottle.
Allow the top to cool (see par.
“Protection against overheating”).
Deactivate the Child Safety function
(see par. “Child Safety Function”).
Wait 60 seconds, then follow the
instructions given in chapter: “In case
of ignition failure”.
Check the correct position (see par. “In
case of ignition failure”)
.
Follow the instructions given in the
section “Cleaning and maintenance”.
Contact an authorized technical
assistance centre
.
See paragraph “How to light a burner”.
S y m p t o n S y m p t o n S y m p t o n S y m p t o n S y m p t o n
THE HOB
DOES NOT WORK.
A BURNER
DOES NOT WORK.
IT TAKES TOO LONG
TO FINISH THE DISHES / THEY ARE
COOKED TOO FAST.
P PP PPossible cause ossible cause ossible cause ossible cause ossible cause
There are blown fuses in the domestic
electrical system. Switches are turned off
or there is no power at the power outlet.
The hob is not activated.
The main gas supply tap is closed.
The gas bottle is empty.
The hob has overheated and a safety device
has been set on the four burners.
The Child Safety function has been
inadvertently activated.
The safety device has been set on the
burner due to repeated ignition failures.
The flame level indicators and the residual
heat indicator flash.
The pan support or the burner cap and
crown were not correctly positioned after
cleaning.
The burner crown holes are obstructed.
The defect persists.
The flame level adjustment is not
appropriate.
If the hob is not working correctly, please carry out the following checks, before contacting your local Service Force repair
agent.
In the event of any other fault codes that arise, disconnect the appliance from the electrical supply for a few seconds (take
outthe fuse from the housing wiring system). If the fault code is displayed again, please call your local Service Force repair
agent and report the fault code.
IMPOR IMPOR IMPOR IMPOR IMPORT T T T TANT ANT ANT ANT ANT::::: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation,
acharge will be made even if the appliance is under guarantee.