14
294000.10040 Rev A
4
Refit the set pin and nyloc nut for the actuator on the leg end first and
tighten to 5 Nm
.
5
Replace the set pin
(after applying threadlock)
that secures the actuator piston to the centre of the cross member and
tighten to 5 Nm
.
6
Replace the plates.
7
Apply loctite to the M6 CSK screws and
tighten them to 5 Nm
.
8
Ensure the leg actuators open and close the legs correctly.
NOTE 1:
Joerns Healthcare recommends Nyloc nuts should always be replaced if undone.
NOTE 2:
Before applying threadlock to any screw or bolt check it can be screwed into the component without hindrance from old
remaining threadlock. This could affect the proper torque setting.
REAR CASTORS
1
Check the front and rear castors are firmly fixed to the legs. Remove any loose castors with a 21mm A/F Spanner, re-
assemble with threadlock.
Tighten to 10 Nm
.
2
Make sure the castors swivel and the wheels rotate freely. Remove any build up of threads, hair or fibres that may clog the
bearings and prevent free rotation. Lubricate if necessary with a light, mineral based grease or silicon spray.
3
Check the action of the brakes on the rear castor. A foot-operated pedal activates the brake. Check the brake pedal locks in
place and that the castor does not move when the brakes are engaged.
NOTE:
Before applying threadlock to any screw or bolt check it can be screwed into the component without hindrance from old
remaining threadlock as this could affect the proper torque setting.
FRONT CASTORS
1
Check the front and rear castors are firmly fixed to the legs. Remove any loose castors with a 17mm A/F Spanner, re-
assemble with Loctite or similar thread locking compound.
Tighten to 10 Nm
.
2
Make sure the castors swivel and the wheels rotate freely. Remove any build up of threads, hair or fibres that may clog the
bearings and prevent free rotation. Lubricate if necessary with a light, mineral based grease or silicon spray.
NOTE:
Before applying threadlock to any screw or bolt check it can be screwed into the component without hindrance from old
remaining threadlock. As this could affect the proper torque setting.
SERVICE & MAINTENANCE
Содержание Oxford Hoyer Professional Elevate
Страница 1: ...294000 10040 Rev A Oxford Hoyer Professional Series SERVICE MANUAL Elevate...
Страница 17: ...17 294000 10040 Rev A EXPLODED VIEW...
Страница 23: ...23 294000 10040 Rev A NOTES...
