Jobsite CT0567, Инструкция по эксплуатации

Страница: 8 / 24

8
11. Set the fuel cock the “OFF” position.
12. Pull the recoil starter handles slowly, until you feel resistance. (At this
point, the decompression just begins and intake/exhaust valves are both
closed, thus the cylinder can be prevented from rust.)
13. Concerning the electric starting engine, directly turn the starting key to
“CLOSE”position.
●
The machine is best suited to the compaction of bituminous and granular
materials e.g. granular soils such as silt and clay are best compacted
using the impact force produced by a vibrating rammer.
●
Where possible the site should be graded and leveled before
commencing compaction.
●
Correct moisture content in soil is vital to proper compaction. Water acts
as a lubricant to help slide soil particles together. Too little moisture
means inadequate compaction; too much moisture leaves water-filled
voids that weaken the soil’s load-bearing ability.
●
Compaction of dry materials will be facilitated by moistening with a water
hose fitted with a sprinkler.
●
Excessive watering or water content will cause the machine to stall.
●
The optional water tank kit is recommended when the machine is used on
bituminous surfaces as the water film prevents a build up of material on
the underside of the plate.
●
The vibratory motion provides a self propelling action. Position the handle
at the opposite end of the machine to the vibrator.
●
For more information on starting and correct operating procedures of the
motor, refer to the motor operation manual supplied with the unit.
●
Increase the motor speed to the maximum setting using the hand throttle
lever, before commencing compacting.
●
The machine should be controlled by grasping the handle with both
hands and applying restraint to control the forward motion.
●
Steer the machine by moving the handle sideways to the right or left.
●
ALWAYS maintain good footing so that you do not slip and loose control
when starting or operating the machine.
●
If the optional water tank is fitted, the flow rate can be controlled by
adjusting the cock in the supply hose to sprinkler bar.
●
Inspect the water hose and its connections to ensure that they do not
leak.