background image

Содержание KWD-2C0

Страница 1: ...of drain line must not exceed center line height of disposer discharge opening 0 6 Mounting screws and spout screws properly tightened to prevent leaks 0 7 Compliance with all aspects of local plumbing code ELECTRICAL CONNECTION 0 1 Properly fused 115 volt 60 hertz branch circuit of 15 ampere capacity 0 2 Disposer properly grounded before operating 0 3 All connections must comply with the National...

Страница 2: ...bber sink flange seal 3 Fig 1 and pressure washer 4 Fig 1 onto the srnk flange by slipping pressure washer over the top set of depressions and turning so that depressions lock pressure washer into place Lift disposer up and into sink flange 1 Fig 1 until snap ring clicks into snap ring groove Finger tighten the two adjusting screws 5 Fig 1 up until they are in contact with pressure washer 4 Fig 1 ...

Страница 3: ...Fig 1 TYPICAL INSTALLATIONS Height of drain should not exceed height of disposer discharge opening Typical P Trap Connection Connection With Straight Away Drain Spout Fig 2 ...

Страница 4: ...ere it is easily accessible Recommended On Off switch suitable for operation of l 2 H P motor Switch not furnished 5 Run Hexible conduit or equivalent from the control switch to the disposer motor leads located in the bearing bracket assembly Insulate connections and connect unit ta ground See Fig 3 and grounding instructions below 6 Run power supply in accordance with local codes from control swi...

Отзывы: