Jobsite CT0567, Инструкция по эксплуатации

Страница: 7 / 24

7
2. Check the engine oil level and top up as necessary.
3. Check the engine fuel level and top up as necessary.
4. Check for fuel and oil leaks.
Start And Stop Procedure
Diesel Engine
1. Open the fuel cock.
2. Turn the governor lever to “STARTING” position.
3. Hold the recoil starter handle.
4. Pull the starter handle until you feel the resistance, then return handle
slowly.
5. Press the decompression lever to “Non-compression” position. The lever
will return back automatically after the engine started.
6. Hold the recoil starter handle with two hands and pull it hardly.
7. It is difficult to start the engine at cold weather. Remove the rubber plug on
the cylinder head and fill about 2CC engine oil before starting.
8. Concerning the electric starting engine, open the fuel cock, turn the
governor lever to “starting” position, turn the electric staring key clockwise to
“starting” position, release the electric starting key after the engine is started.
If the engine could not start after the starting motor ran ten seconds, start it
again after 15 seconds. (Run the starting motor for long time will cost the
battery power greatly even burn out the motor.)
9. To stop the engine, set the governor lever to the low speed position, then
run the engine at zero load five minutes.
10. Set the governor lever to the “STOP” position. Do not stop the engine
with the decompression lever.